FLORCOTE WB
WELCOME TO THE NEXT GENERATION
IN CONCRETE SEALING TECHNOLOGY

 

 

 

 


WATER BASED EPOXY-ACRYLIC COATING

 

 


PURPOSE:
THROUGH THE ADVANCEMENT OF POLYMER TECHNOLOGY, TECHLITE HAS DEVELOPED A NEW
TWO-COMPONENT, EPOXY-AMINE WATER BASED COATING WITH THE PERFORMANCE
CHARACTERISTICS OF CONVENTIONAL SOLVENT BASED SYSTEMS.

THIS COATING IS SPECIFICALLY DESIGNED FOR INTERIOR USE WHERE AN EXTREMELY ABRASION RESISTANT, WASHABLE AND CHEMICAL RESISTANT COATING IS NEEDED. DAIRIES,
MEAT-PACKING PLANTS, FOOD PROCESSING PLANTS, HOSPITALS AND SCHOOLS ARE BUT A FEW EXAMPLES OF TYPICAL APPLICATION AREAS.

FLORCOTE WB CAN BE APPLIED ON GREEN OR AGED CONCRETE, MASONRY, WALLBOARDS, PLASTER, WOOD, PROPERLY PRIMED STEEL, ALUMINUM, AND OTHER METALS.

ADVANTAGES:
- VIRTUALLY ODORLESS
- LONG POT-LIFE (6-8 HRS.)
- COMPATIBLE WITH MOST LATEX PRIMERS AND “FILLER” COATINGS
- TILE-LIKE HIGH GLOSS AND SEMI-GLOSS FINISHERS AVAILABLE
- WIDE VARIETY OF COLORS AVAILABLE
- EQUIPMENT CLEANED WITH WATER
- EXCELLENT ADHESION TO UNTREATED AND TREATED STEEL, GALVANIZED METAL, ALUMINUM, AND AGED ALKYD AND EPOXY ENAMEL FILMS
- NO BLEED THROUGH WHEN APPLIED TO ASPHALTIC SURFACES
- COMPONENTS ARE NOT EMULSIONS, THEREFORE NO COALESING OR FREEZE-THAW PROBLEMS
 

TECHNICAL DATA:

 

VISCOSITY:

90-100 KU MIXED

GLOSS:

GREATER THAN 95% AT 60 DEGREES

HARDNESS:

GREATER THAN 25 SWARD AT I WEEK CURE

ABRASION RESISTANCE:

LESS THAN .35 MGM NET LOSS (CS-I7 WHEEL
1000 CYCLES, 500 GRAMS)

 

 

 

APPLICATION DATA:

 

MIXING RATIO:

1:1 -A:B BY VOLUME

POT LIFE:

6-8 HOURS

DRYING TIME F. AND 50% RH:

TO TOUCH: 4 HOURS - CURED: 7 DAYS

COVERAGE:

250-350 SQ. FT. PER GALLON DEPENDING ON
POROSITY AND SURFACE TEXTURE

 

COMMENTS:
TWO COATS ARE RECOMMENDED FOR OPTIMUM PERFORMANCE CHARACTERISTICS.
REDUCED MIXED SYSTEMS TO 10% WITH WATER TO FACILITATE SPRAYING.
DO NOT ADD TO ANY OTHER CHEMICALS OR SOLVENT TO THE MIXED COMPONENTS.

CHEMICAL RESISTANCE:
EQUIVALENT TO CONVENTIONAL SOLVENT-BASED EPOXY-POLYAM1DE SYSTEMS, FOR MOST
CORROSIVE CHEMICALS.

ENVIRONMENTAL LIMITS:
TEMPERATURE - DO NOT APPLY WHEN AIR, SUBSTRATE, OR MATERIAL TEMPERATURES ARE BELOW 50 DEGREES F.
APPLY CURED COATING “IN USE” RANGE IS +200 DEGREES F. TO —25 DEGREES F.

 


 

 

Epoxy Liquids

Liq Ice Melt


13900 Jog Road Ste. 203-208
Delray Beach, FL 33446

FOR PRICING AND PACKAGING, PLEASE CALL:

Phone:  (612) 371-4446
Toll Free:  (800) 879-9729
Fax:  (612) 371-4577

Email: sk@techliteproducts.com

Copyright © 1998-2014 TECHLite Products Corp.   All rights reserved.
All specifications subject to change without notice.
Other products referred to herein are trademarks or
registered trademarks of their respective companies or mark holders.